22
Installation of the Control
Installation of Bluetooth Receiver
Locate a safe location in the cab of the tractor to place the Bluetooth
Receiver (030-4672A). Recommended location is as close to the iPad
being used as possible.
Connect communication wire (006-4660N) to the bottom of the receiver.
Optional Touch Screen Display
Use suction cup mount (001-2012SCM) to position the monitor in the
cab. Make sure the glass is clean before installing the suction cup mount.
If an open cabbed tractor is used, use the supplied #10 screws for
installation on the fender. If unit is mounted on fender it will need to be
removed at night and stored in a clean, dry area. Use the Ram mount
(001-2012H) swivel-positioning nut to tighten the entire assembly. Adjust
it so that you can view the entire screen and be able to use the touch
screen without interfering with other tractor functions.
Connect communication wire (006-4660N) to the bottom of the terminal.
7. Installation of Display Cable Harness
On the bottom of the touch screen display you will find the main display wire plug. The harness (006-
4660N) will need to be attached to this plug and run through the cab towards the hitch where it will
connect with its matching harness (006-4660L) from the BMP.