4
Installation of Applicator
Installation of Mounting Brackets, Tank, Pump Manifold & Hose Manifold
Model 444T
Tank legs will be mounted to the back side of the baler behind knotters and before the bale tensioner (figure1).
Using figure 2 as a reference, mark the two holes on each side of bale chamber that need to be drilled. Line up
saddle leg on each side to verify holes before drilling, show in f
igure 3. Drill all four holes to 1/2” in size.
Bolt legs to baler with 1/2” x 1 3/4” Allen button head bolts, flat washer, Lock washer, and nuts.
*Note: bolt head is on inside of bale chamber. Level top of leg before completely tightening bolts, figure 4.
Bale Thrower - Additional Bracket
When baler is equipped with a bale thrower, bracket (001-4703QC) will need to be used. First secure the
kicker so it will not rotate when you remove the front pin on the hydraulic cylinder. Remove pin, Install tank leg
over mount. Reinstall pin. Use part 001-4703QC which is a spacer that will go between the leg and side of the
baler to take up the space the throwers front hydraulic mount adds.
Figure 1
Figure 2
Figure 3
Figure 4