Hartmann DC3-18, Instructions For Use Manual

Page: 28 / 152

28
English
EN
If there is no morning or evening value for the past 7 days
in the memory, dashes will be shown on the display
instead of the morning or evening average values. If no
values at all are stored in the memory, then dashes will
also be displayed instead of the overal average value.
Individual measured values
■ ■
By pressing the key (or the key if you are in user
memory 2) again, all saved values can be retrieved one
after the other, starting with the most recent measured
value.
■ ■
If an irregular heartbeat or arrhythmia was detected during measurement,
that information is also stored and displayed when the measured value
is retrieved from the monitor‘s memory, along with the systolic and diastolic
blood pressure values, pulse rate, time and date.
■ ■
The symbols , or (see Chapter 5.4) are also saved together
with the individual measured value if they were displayed during the
measurement.
■ ■
You can cancel the memory recall at any time by pressing the START/STOP
key . Otherwise, the device will switch off automatically after 30 seconds.
■ ■
The saved values will still be available even if the power supply has been
interrupted, e.g. due to changing the batteries.
Deleting saved readings
All data saved for each user can be separately deleted for
user memory and user memory . Press the key for the
corresponding user memory ( or ). The average value ' ‘
appears on the display. Now hold the user memory key for
4 seconds until the display starts to flash, apart from the
symbols and or . If you hold the memory key down
for another 4 seconds, all data for the selected user memory
will be deleted. To indicate this, dashes will be shown on the
display instead of numerical values.
IFU_Veroval_dc_SK6_0307662_2020-02-10.indd 28 27.02.20 13:09