Harris Legacy 99-1300-0, Operation & Technical Manual

Page: 64 / 98

Revision B • 1/03
H A R R I S C O R P O R A T I O N
2-52
2 Installation
PIN # SIGNAL FUNCTION
1 LOGIC GROUND Module logic ground.
2 LOGIC GROUND Module logic ground.
3 LOGIC GROUND Module logic ground.
4 STOP COMMAND PULSE Stop command output. N/O relay contact.
5 START COMMAND PULSE Start command output. N/O relay contact.
6 LOGIC 5VDC 5 volt source.
7 ON INPUT (-) Remote On switch input (active low).
8 OFF INPUT (-) Remote Off switch input (active low).
9 COUGH INPUT (-) Remote Cough switch input (active low).
10 LOGIC 5VDC 5 volt source.
11 LOGIC 5VDC 5 volt source.
12 LOGIC 5VDC 5 volt source.
13 COMMAND COMMON Start/Stop Pulse, Start Sustained common. C relay contact.
14 TALLY RELAYS COMMON Tally relays common connection. C relay contact.
15 LOGIC ACTIVE TALLY Logic active tally output. N/O relay contact.
16 OFF TALLY Off tally output. N/O relay contact.
17 ON TALLY On tally output. N/O relay contact.
18 ACTIVATE INPUTS (+) +VDC to enable external inputs On, Off, Cough, Talkback.
19 RESET (-) Remote Audio Off input (active low).
20 TALK TO C/R INPUT (-) Remote Talkback input (active low).
21 READY (-) Remote Ready input (active low).
22 RESET (+) +VDC to enable Audio Reset function (audio off control).
23 START SUSTAINED Start sustained command output. N/O relay contact.
24 READY (+) +VDC to enable the Ready function (Off lamp control).
Notes: +VDC is b5 and +40 VDC.
Output relays can switch voltages up to +60 VDC
Bold indicates connections used in this example.
UNIVERSAL INPUT MODULE LOGIC CONNECTOR SIGNAL TABLE
12
11
10
9
8
7
6
5
4
3
2
1
24
23
22
21
20
19
18
17
16
15
14
13
(wire insertion
end view)
Basic Logic Connection Example
This example shows how to set up a Universal Input module (A input) to interface with a CD
player, such as the Denon DN-951/961. For more information on logic connections and DIP
switch settings for the Universal Input module, see pages 2-18 through 2-21.
DS1 AND DS2 SWITCH SETTINGS, AS USED WITH A CD PLAYER
# Switch Name Setting
1 Signal Source * ON
2 CR Mute OFF
3 Studio Mute OFF
4 Spare Switch
5 External Site Mute OFF
6 Local ON Cough OFF
7 Timer Reset ON
8 Off Lamp Control OFF
DS1
# Switch Name Setting
1 Fader Start OFF
2 Start Pulse OFF
3 Start/Stop Pulse OFF
4 Bypass SRC Converter OFF
5 Spare Switch OFF
6 Spare Switch OFF
7 Input Level Set A OFF
8 Input Level Set B OFF
DS2
Note: Set the switch to the operator’s left for ON. Set the switch to the operator’s right for OFF.
* Digital input shown