Harris Legacy 99-1300-0, Operation & Technical Manual

Page: 45 / 98

2 Installation
Revision B • 1/03
H A R R I S C O R P O R A T I O N
2-33
SETUP
SETUP — These eight DIP switches affect logic functionality for the module per the Control
Room Module Switch Definitions below.
Control Room Module Switch Definitions
# Switch Name ON Function (set to operator’s left) OFF Function (set to operator's right)
1 Operator Headphone Cue feeds left channel, monitor feeds right, Stereo Cue is fed to Operator output
AutoCue function while Cue is active and AutoCue is On while Cue is active and AutoCue is On.
2 Talkback into Co-Host Talkback to C/R also fed to the Does not route talkback to C/R to the
Headphone Co-Host headphone output Co-Host headphone output
3 Talkback into Cue Talkback to C/R is added to the Talkback to C/R does not feed the
Cue output Cue output (only feeds Talkback output)
4 Dim Monitors when Dims monitors by 12 dB when receiving Does not dim monitors when receiving
Receiving Talkback Talk to C/R signal Talk to C/R signal
5 Auto-switch External Performs automatic switching from Does not perform automatic switching
Inputs 1 & 2 * Ext. Input 1 to Ext. Input 2 while there is a
live mic in the Control Room
6 Auto-switch External Performs automatic switching from Does not perform automatic switching
Inputs 3 & 4 * Ext. Input 3 to Ext. Input 4 while there is a
live mic in the Control Room
7 Spare Switch
8 Spare Switch
CONTROL ROOM MODULE SWITCHES
* Switch 5 (or 6), when set to On, automatically switches the Operator, Co-Host, and Guest headphone outputs between an
air monitor signal on External Input 1 (or External Input 3), which has an objectionably long propagation delay, with a
synthetic air signal (with relatively little delay) connected to External Input 2 (or External Input 4). Note that to do this the
monitor source must be set to External Input 1 (or External 3).