Harris Legacy 99-1300-0, Operation & Technical Manual

Page: 60 / 98

Revision B • 1/03
H A R R I S C O R P O R A T I O N
2-48
2 Installation
QUICK GUIDE TO THE OUTPUT 2 MODULE
There are fourteen connectors on the Output 2 module: seven 6-pin analog audio output connec-
tors and seven 3-pin digital audio output connectors. The connectors are hidden by the meter panel
in normal operation.
ANALOG OUTPUTS
PGM-1, PGM-2 — Each bus has an isolated MAIN and AUXiliary analog
output. The outputs are wired using the standard stereo pinout sequence.
PGM-3, PGM-4 — There is a single analog output for each of these
Program buses. They are wired using the standard stereo pinout sequence.
SEND — Analog output of the Send bus. It is wired using the standard
stereo pinout sequence.
DIGITAL OUTPUTS
PGM-1, PGM-2 — There are two digital outputs (MAIN and AUXiliary)
for each of the Program 1 and Program 2 buses. All outputs are AES-3
(AES/EBU) compatible. The MAIN outputs are fixed at a 48 kHz sample
rate. The AUX outputs are DIP switch-set between 48 kHz and 44.1 kHz.
PGM-3, PGM-4, and SEND — There is a single digital output for
each of the Program 3, Program 4, and Send buses. All the outputs are AES-
3 (AES/EBU) compatible. Each output can be individually set (via DIP
switch) for either 48 kHz or 44.1 kHz sample rates.
Analog Outputs
Right High (+)
Right Low (-)
Shield
Left High (+)
Left Low (-)
Shield
3
2
1
6
5
4
(wire insertion end view)
Digital Outputs
High (+)
Low (-)
Shield
(wire insertion end view)
3
2
1