Harris Legacy 99-1300-0, Operation & Technical Manual

Page: 41 / 98

2 Installation
Revision B • 1/03
H A R R I S C O R P O R A T I O N
2-29
SETUP
1 - 8 — These eight DIP switches affect various logic settings for the console per the Meter
Switcher Module Switch Definitions table below.
Meter Switcher Module Switch Definitions
# Switch Name ON Function (set to operator’s left) OFF Function (set to operator's right)
1 Spare Switch
2 Spare Switch
3 Cancel Cue Cue function for that channel is turned Cue is not affected when the module
at Module On off when the module is turned On is turned On
4 Cue LED Blink Cue LED blinks while Cue is on Cue LED is solid while Cue is on
5 Spare Switch
6 Off-Line Signal The Off-Line audio feed level is The Off-Line audio feed is not affected by the
Level controlled by the fader (post-fader) module fader (pre-fader)
7 Spare Switch
8 Spare Switch
METER SWITCHER MODULE SWITCHES
RESET
(SEE MANUAL) — This push-button switch resets the installed input and monitor modules
to their factory default settings without powering down the console. Typically, this switch is
used only for test purposes since it does not reset the DSP cards.
CONSOLE RESET