Harmonic ELECTRA VS, User Manual

Page: 115 / 604

Chapter 3 ’Web User Graphical Interface’ — Operating Instructions (Tutorial)
Electra VS - Version 05.10 115
User Manual - Rev. A
- Multicast, IGMP v3: IGMP v3 request uses the SSM mode
and can specify the source IP address. Only multicast with
the specified source IP address will be received.
- Unicast: when a datagram is received, it is discarded if it
does not come from the specified source IP address.
d. Indicate a maximum TS bitrate, in bits per second.
This parameter is used not to saturate the node input network.
The entered value can be higher than the actual bitrate (e.g.
40 Mbps for 38 Mbps actual rate). If the entered value is lower
than the actual bitrate, a congestion is likely to occur on the
receiving node.
e. Indicate the standard ( DVB , MPEG-2 , ATSC ).
For a TS file input:
Figure 3-49. Creating a new snapshot view for a TS file input
a. Enter the network storage where the TS file to use as a source is
stored.
b. Enter the name of the folder on the network storage where the
TS file to use as a source is stored.
c. Enter the name of the TS file to use as a source.
4. Select the standard of the input stream: MPEG-2, DVB or ATSC.
The snapshot view is automatically created and updated.