Control panel
11
•
RED
: Error detected.
- If
ERROR MODE
is set to
NORMAL
, the error message will be shown in the display.
- If
ERROR MODE
is set to
SILENT
, display the error message by entering the menus and going to
SERVICE
→
ERROR LIST
.
•
FLASHING
: No DMX signal detected.
•
CONSTANT
: Valid DMX signal detected.
The status LED remains active even if the display enters sleep mode.
Battery power
Warning!
The fixture’s lithium battery is not rechargeable. Do not try to recharge it. Battery replacement
must be carried out by an authorized Martin service agent with service instructions from Martin. If the
battery is discharged, contact an authorized Martin service agent for replacement.
The MAC Aura XIP contains a lithium battery that gives access to the most important functions in the control
panel when the fixture is not connected to AC power. The following functions are available on battery power:
• DMX address
• DMX Mode
• Fixture ID
• Personality settings (pan/tilt, cooling, fan clean mode, dimming curve, DMX reset, parameter shortcuts, all
display settings, error mode)
• Default settings
• Information (Power On Hours and Power Cycles counters, Software version)
• Error list
To activate the display when the fixture is not connected to power, press the MENU button
I
. Press again to
enter the menus. The display extinguishes after 10 seconds with no user input and the control panel is
de-activated after 1 minute with no user input. Press the MENU button
I
again to re-activate.
Shortcuts
If you hold the MENU button
I
pressed in for 2 - 3 seconds, a shortcut menu with the most important
commands appears. Select a command with the UP and DOWN buttons
J
and press the ENTER button
K
to activate, or press the MENU button
I
again to cancel.
•
RESET ALL
resets the whole fixture
•
ROTATE DISPLAY
rotates the MAC Aura XIP display 180°
Settings stored permanently
The following settings are stored permanently in the fixture memory and are not affected by powering the
MAC Aura XIP off and on or by updating the fixture software:
• DMX address
• DMX mode
• DMX universe
• Fixture ID
• Personality settings (pan/tilt, cooling, dimming curve, DMX reset, effect shortcuts, display settings, error
mode, etc.)
• Resettable and non-resettable counters
• Service settings (adjustment, calibration)
These settings can be returned to factory defaults using the control menus or via DMX.
