1. Connect the oscilloscope to a PictBridge compatible printer.
●
Insert
one end of a USB cable into the USB Device port on the oscilloscope.
●
Insert
the other end of the cable into the PictBridge port on a PictBridge
compatible printer.
2. Print a Screen image
●
Power
on the oscilloscope and the printer (The printer recognizes the
oscilloscope only when the printer is powered on).
●
Press
the UTILITY button to display UTILITY menu.
●
Press
the Next Page option button.
●
Press
the Back USB option button to select Printer
●
Press
the Print Setup option button to display Print setup menu.
●
Set
up the print setup option according to your need. The oscilloscope
queries the printer, and only displays options and values that the printer
supports.If you are not sure which setting to choose, select Default for
each option.
●
Press
the Print Key option button to select Print Picture.
●
Press
the PRINT button to print screen image.
The oscilloscope takes a few seconds to capture the screen image. The
settings of your printer and print speed determine how long it takes to print
the data. Additional time may be required according to the format selected.
2.13.4 Self Calibration
Self Calibration procedure can optimize the signal path at the most measurement
precision..You can run this procedure at any time. If the operating temperature
changes by more than 5 C or the units run less than thirty minutes,you should do
the self calibration.
Note
1. Before connecting the oscilloscope to the printer, you must be sure that Back USB
option having been settled to Printer.
. You can use the oscilloscope while the printer is using.
. If printing fails, check wthether the USB cable is connected to the PictBridge port on
the printer or not. If the connection is OK, but the printing is still failing, you can turn
on and off the printer or oscilloscope again, before you turn on and off the printer or
oscilloscope again , you must first disconnect the connection between USB cable and
USB Host port of the Printer or USB Device port of the oscilloscope, then try again.
.
2
.
If you want to use oscilloscope connecting to your Computer, youmust be sure that
“ B
ack
U
SB
” o
ption
h
aving
b
een
s
etted
t
o
“C
omputer
”
3
4
5
The RS-232 cable usually has needle shape(male) on one
side, while hole shape(female) on the other side.
To print screen picture, follow these steps:
90
Digital
S
torage
O
scilloscope
Digital Storage Oscilloscope
91
When you run the self Calibration, you should cut off all the probes and lead.
Then press the Utility button to choose the Do self cal to show the self
Calibration Menu, and execute self calibration program according to the prompting
on the screen.
