Page EN-33
Mounting the front panel
(Not required for substructure model)
You can mount a front panel on the dishwash-
er door which matches your kitchen. The front
panel must not exceed a weight of 5 kg.
1. Hold the front panel against the dish-
washer door such that the lower side of
the front panel is flush with the adjoining
kitchen cupboards.
2. Measure the distance between the front
panel and the control panel.
(d)
3. A gap of 5 mm to 25 mm can be off-
set with the 5 mouldings (d) included.
Remove the required number of trim
strip from the block. To do so, move the
moulding vigorously but without using
tools.
4. If you only need one trim strip, saw off
the four feet that stick out,
clamp the trim strip under
the control panel and secure
it using both countersunk
screws (l).
Continue with Step 7.
5. If you need more than one trim strip, turn
the lower trim strip and push it onto the
other trim strips. This hides the feet and
makes the surfaces flat.
6. If you
– need 2 trim strips, secure these using
both countersunk screws (l).
– need 3 trim strips, secure these using
both countersunk screws (m).
– need 4 to 5 trim strips, secure these us-
ing both countersunk screws (n).
(f)
7. Pull the two pairs of velcro straps (f)
apart.
8. Remove the protective film from the
same type of velcro strap.
(f)
(f)
9. With the protective film removed, stick
the velcro straps (f) onto the middle of
the recessed areas on the dishwasher
door.
10. Cut the positions of the velcro straps out
of the drilling template.
11. Cut the number of trim strips used off the
drilling template.
Mounting the front panel
