8. Assembly and Operation
Assembly
1.
Install the Drag Assembly using hammer (Except part No. 38, 39 and 40)
2.
Install the bowl into the drag hole located in frame
3.
Install the sample collector.
4.
Close the front door and lock using the hammer.
5.
Press down the spindle (caution : Part No. 8 and 9 should be located in straight line)
6.
After confirm the clutch on no. 4, connect the spindle and bowl using hammer and
wrench.
7.
Press down the spindle sleeve cap and tighten the srew.
8.
Connect the 38, 39 and 40 on the Drag Assembly with hammer.
9.
Connect the sample in Line hose.
10.
Input the grease cap.
11.
Reconfirm all the procedure again and operate the motor.
[email protected] / [email protected]
ㅣ
16
Summary of Contents for J1250
