HANGCHA XF Series, Operation Manual

Page: 17 / 73

14
interval between consecutive starts should be
120s.
Lifting lever [5]
This lever is used to lift or lower the forks.
Push forward - Down; Pull back - Up
The lifting speed is controlled by the backward
tilt angle of the lever and the accelerator pedal.
The lowering speed is only controlled by the
forward tilt angle of the lever.
Tilt lever [6]
This lever is used to tilt the mast forward and
backward.
Push forward - Forward tilt; Pull back -
Backward tilt
The tilt speed is determined by the tilt angle of
the lever and the throttle control.
Caution
The multiway valve is equipped with a
forward tilt self
- locking valve. Therefore,
when the engine shuts down, the mast
cannot tilt forward even if the tilt lever is
pushed forward.
Side shift control lever (optional)
Accessory control lever (optional)
This lever is used to move the side shift frame
to the left or right.
Push forward – Move left; Pull back – Move
right
The side shift speed is determined by the tilt
angle of the lever and the throttle control.
Different types of accessories with different
functions are optional, thus the driver has to
be familiar with the operating method for each
accessory.
Cup holder [7]
A cup holder is set on the right side of the
instrument stand for the driver to place a cup.
Rocker switch [9] [optional configuration]
1. Alarm light switch: When pressing down, the
alarm light will flash; when pressing up, the
alarm light will turn off.
2. Rear headlight switch: When pressing down,
the rear headlight will turn on; when pressing
up, the rear headlight will turn off.
Rocker switch in a truck with a cab may be
different. Ventilation, demisting or other
Lift
Lower
Tilt forward
Tilt backward
Move to the left
Move to the right