55
PARTS REQUIRED:
AUGER STAKES
12"
(30,5 cm)
12"
(30,5 cm)
FINISH
BEGIN
1
After the fl oor is in the fi nal location, install (6) augers as shown, at measured locations
.
Secure the augers to bond boards with 2-1/2" lag screws and 2" fl at washers
(Fig. A)
.
HINT:
When installing augers in rocky or hard soil, create a starter hole at the desired locations using either a
16" Concrete Drill Bit, or a long screw driver, then insert and install the augers as shown. This will allow you to
get traction with the Earth Auger and allow the device to seat more securely.
Use a large screwdriver or metal rod to twist the augers into the ground until auger loop is at the correct height.
Your Earth Augers are now installed.
Return to Page 15 to begin building your walls.
x6
30" Earth Auger
Large Screwdriver
Ratchet Handle
& Socket
CENTER
CENTER
Fig. A
Min. 1-1/4"
(3,2 cm) for siding clearance.
2-1/2"
Lag Screw
2" Flat Washer
Floor Deck
Bond
Board
x6
1/2" x 2" x 2"
(13 mm x 50,8 mm)
Flat Washer
x6
5/8" x 2-1/2"
(16 mm x 6,3 cm)
Lag Screw