H&S 2958, Operator'S Manual

Page: 49 / 54

- 8.2 -
8.12 Hydraulic Deflector Kit Installation
4. Install the second cylinder mounting pin
(3-1/4”), secure with 3/8” bolt, washer, and
lock
nut.
5. Extend the cylinder to its maximum point
of extension, making sure that the
deflector shield does not come closer than
1” away from contacting the bale shroud.
6. After making sure the deflector shield is
free to move without hitting the bale
shroud, retract the cylinder until it is
closed. Watch to make sure that cylinder
does not put excessive pressure upwards
on the deflector shield in this position.
If there is excessive pressure on the deflector shield, loosen the bolts holding the
top cylinder mount, and adjust its position down slightly within the slotted holes.
After adjusting the top cylinder mount, recheck that the deflector does not come
closer than 1” away from contacting the bale shroud. Further adjustment is
available by positioning the table and support brackets as necessary.