Halstead Eden CBX, Installation And Servicing Instructions

Page: 19 / 47

17
APPLIANCE INSTALLATION
4
4.1
UNPACKING THE APPLIANCE
The appliance is supplied in one box. Flue kits are provided
separately, the various flue kits available as described in sections
2.5 - 2.7. If the appliance is to be installed without access to an
external wall, a wall liner kit is also required.
Unpack the boxes and check the contents:
G
Complete appliance
G
Paper wall mounting template
G
Wall mounting plate
G
Plumbing jig
G
Installation and Servicing Instruction
G
User's Instructions
G
Benchmark book
G
Hardware pack containing:
50 mm x No 10 wood screws - 4 off
Wall plugs - 4 off
22 mm copper street elbows -
2 off (3 off SBX appliance)
Before installing the appliance, check that the chosen location is
suitable (section 3.2) and that the requirements for flue position
(section 3.3) and minimum clearances (Figure 1b) are satisfied.
Manual Handling Note: During the appliance
installation it will be necessary to employ caution and
assistance whilst lifting, as the appliance exceeds the
recommended weight for a one-man lift. Take care to
avoid trip hazards, slippery or wet surfaces.
4.2
PREPARING THE WALL
a) Fix the paper template in the required position (ensuring that
the necessary clearances are achieved). Ensure squareness by
hanging a plumb line.
b) Mark the position of the wall mounting plate-fixing holes (4).
Select one from each group. Refer to Figure 10.
c) Mark the position of the flue outlet. For side flue installation
extend the flue centre line on to the sidewall, where the flue
length exceeds 775 mm, a flue slope angle of 2.5° needs to be
taken into account. Refer to Figure 10. Remove the paper
template.
d) Cut the hole in the wall for the air/flue duct (preferably with a
core-boring tool). The hole must be horizontal and not be less
than 100 mm in diameter. If the hole is not accessible from
outside, its minimum diameter must be sufficient to allow insertion
of the wall liner (130 mm, 5in). The wall liner is available as an
optional extra and must be sealed in position with mortar (or
equivalent).
e) Drill the four fixing holes using a 6mm drill and insert the wall
plugs provided.
f) Hang the wall mounting plate using two fixing screws in the
top, ensuring that it is level. Hook the plumbing jig onto the two
bottom locating tabs of the wall mounting plate. Refer to Figure 9.
g) Enter the bottom two fixing screws into the wall plugs and
tighten up all four screws.
If required, service connections may be made now
before mounting the appliance - Refer to section 5.
Pipe work may be routed from above or below the
appliance as required.
9
CBX
SBX