Hakko Electronics V Series, Connection Manual

Page: 309 / 332

App6-40
Appendix 6 Universal Serial Communications
Switch Output (See page App6-16, page App6-23 and page App6-38.)
When [Output Action] of a switch is set to [Momentary] and [Output Memory] is set in location
($s80-95) of system memory, the following actions occur when the switch is pressed.
When the bit memory specified in system memory is set, and the switch is released, it is reset.
The switch number that corresponds to the bit is written in write areas n + 3 and n + 4.
For the relationship between the bit and the switch number, refer to page App6-46.
•
V series analog type
Normally, only one switch can be pressed. (Fixed to 1 output)
However, if you go from the menu bar to [System Setting] to [Function Switch Setting] (or if you go
from the menu bar to [Edit] to [Local Function Switch Setting]), and check [Use Function Switch], it
is possible to press two points (2 outputs) at the same time.
For 1 output ([Use Function Switch] is not checked), the switch number and switch information are
written in n + 3. For 2 outputs ([Use Function Switch] is checked), the switch number and switch
information are written in n + 3 and n+ + 4 when two points are pressed.
•
V series matrix type
When you go from the menu bar to [Edit] to [Screen Setting], you can select between 1output or 2
outputs. For 1 output, the switch number and switch information are written in n + 3. For 2
outputs, the switch number and switch information are written in n + 3 and n + 4 when 2 switches
are pressed simultaneously.