Hakko Electronics V Series, Connection Manual

Page: 234 / 332

Appendix 5 Ethernet
App5-9
Transferring Screen Data
This section describes the procedure for transferring screen data from the V-SFT editor on the server
to MONITOUCH via Ethernet.
For the procedure using the V6-CP cable, refer to the Reference Manual (Operation).
Prerequisites
When screen data is to be transferred for the first time via Ethernet or when the V7 series has been
replaced due to trouble, the server cannot transfer screen data because the network table has not
been transferred to the V7 series.
In this case, the following setting must be made on the Main Menu screen:
- IP address
- Default gateway
- Subnet mask
The port number must be “10000.”
When the network table is transferred from the V-SFT editor, the above data is updated.
•
Setting Procedure
1. Press the [Ethernet] switch on the Main Menu screen.
2. The Ethernet screen is displayed. (For more information, refer to “Chapter 6, MONITOUCH
Operations” in the V7 Hardware Specifications Manual or V706 Hardware Specifications
Manual.)
Set the IP address. If necessary, set the default gateway and subnet mask.
(When attaching the I/F unit CU-03-2 to V7, set the connecting method (10BASE-T/AUI) as
well.)
3. When the setting has been completed, press the [Setting Finished] switch. The Main Menu
screen is displayed again.
4. The setting data can be reviewed on the Main Menu screen.
5. Transfer screen data from the server.
Time-Out : 0.50 sec
2002-4 -1 07:23:30
SYSTEM PROG. VER. 1.010
FONT
VER.1.300 / 1.000 / 1.000
ENGLISH I/F DRV VER.1.310
YOKOGAWA FA-M3
Ethernet
Editor:MJ1
Main Menu V 7 1 0 i T D
System Information
PLC Type : YOKOGAWAFA-M3/FA-M3R(Ethernet)
Comment :
Screen Data
Information
Size : 5783552
SRAM/Clock
Ethernet
Card
Menu
I/O Test
Retry : 3
PORT: 10000
MAC: 0050FF000035
Ethernet Information PORT: 10000
MAC: 0050FF000035
Trans.Speed : 10BASE-T
Stat. No. : 192.168.1.68
Ethernet Information
Trans.Speed : 10BASE-T
Error : Stop
Stat. No. : 192.168.1.68