Segmented mandrel T213 – Assembly
The work piece must be clamped into the clamping
device with sufficient work piece tension.
Do a pressure loss test and a measurement of
clamping force.
6.6 Control of the stroke position
WARNING!
Crushing danger from moving parts!
Crushing danger from moving parts during
controlling the stroke position!
Gaps, caused while controlling the stroke posi-
tion, can cause severe injury.
Only do the controlling of the stroke position
with assembled changing parts.
Only run the machine in set-up mode or jog
mode.
Do not reach into moving parts or handle mov-
ing parts during operation.
Note the gap dimensions of moving parts.
Wearing of gloves / [PSA] is required!
6.7 Activities after production is concluded
8. x
1. Move the clamping device into unclamped position.
2. Switch off the machine tool and safeguard it from
being switched on again.
3. Open the protective door or hood.
4. Clean the clamping device and a possibly mounted
adaptation clamping device and adapter of chips
and production residues using a soft, lint-free cloth
and oil them lightly.
5. Close the protective door or hood.
48
Order h49 7144.907-333
