hs dock
Faults
86
Order h49 7144.907-333
Fault
Possible cause
Remedial action
Remedied by
Geometry devia-
tion on the work-
piece
Axial run-out error
on the actuating
unit
Check axial run-out of the clamp-
ing device and the actuating unit
and correct if necessary
Skilled special-
ist
Face run-out error
on the actuating
unit
Check face run-out of the clamp-
ing device and of the actuating
unit and clean the mating surfaces
if necessary
Table 13: Fault table
13.3 Commissioning after a fault has been remedied
After the fault has been remedied, perform the following
steps to recommission it:
1. Reset the emergency stop equipment.
2. Acknowledge the fault on the control unit of the machine
tool.
3. Ensure that no-one is in the danger area.
4. Start the machine tool.