hs dock
Installation
Order h49 7144.907-333
45
If the face run-out is greater than the maximum permitted
value:
1. Remove the product.
2. Clean the locating face and the mating faces of the ma-
chine table / the baseplate and the product.
3. If there is a burr or slight damage to the locating face of
the product and the machine table / the baseplate, rub it
down gently with an oil stone.
4. Reinstall the product.
5. Repeat the alignment process.
6. Repeat the face run-out test.
7.5.6 Installation of the hydraulic port variant of the product to the side of the
product - secured using fixing screws
1. Depressurize the hydraulic unit.
DANGER
Serious injuries caused by projectile workpieces,
ejected by incorrectly connected hydraulic ports!
The hydraulic connections on the machine and
the baseplate must be connected up correctly.
The »Clamping« hydraulic ports on machine and
baseplate must be connected together. The same
applies to the »Release« ports.
WARNING
Serious injuries can be caused by escaping media
when seals and damaged / missing!
Replace missing or damaged sealing elements.
Ensure that the sealing elements do not fall out or
get damaged during installation / removal, and
apply a thin coat of grease if necessary.
2. If necessary, fit the baseplate to the machine table. To
do this, the hydraulic ports on machine and baseplate
must be aligned with one another.
3. Attach any lifting gear that may be required.
4. If necessary, fit the mounting aid onto a vertically sus-
pended spindle.
