Page 10
STEP 4
Press the down arrow to display the next named device.
Using the worksheet(s) as a guide, configure all named units as described in Step 2 and Step 3.
STEP 5
Configure Unnamed Room Controllers
Room Controllers that reside between the 2nd and 7th unit in a Room should be unnamed. To configure a Room Controller between
the 2nd and 7th unit in a Room, enter its Unit Number followed by the ' # ' key.
Put the Room Controller into Setup mode as descried under
“Room Controller Setup”
in Step 2.
Back at the Lumina keypad, press ' # # '. The display shows:
CONFIGURE UNIT 2
STARTING
The display will provide you with step-by-step configuration status. When complete, the display shows:
CONFIGURE UNIT 2
COMPLETED
Once completed, press the ' * ' key to return to the Status display. Repeat Step 5 for each unnamed Room Controller.
STEP 6
Configure Unnamed House Controllers
House Controllers that reside on the 8th unit in a Room should be unnamed. To configure a House Controller on the 8th unit in a
Room, enter its Unit Number followed by the ' # ' key.
Go to the specified HAI UPB™ 8-Button House Controller and put it in Setup mode as follows:
House Controller Setup
Step Operation
1
Press and hold the “1” and “8” pushbuttons simultaneously for at least 3 seconds.
2
All of the LED indicators will blink to indicate that the HAI UPB™ 8-Button House Controller is in Setup Mode.
Note:
The HAI 8-Button House Controller will automatically exit Setup mode after 5 minutes. To manually exit Setup
mode, press and hold the “1” and “8” pushbuttons simultaneously for at least 3 seconds.
