IV.
OPERATING SYSTEMS
54
D. SPRAY SYSTEMS
SIDE- FILL OPERATION–
The solution tank is filled using an operator supplied loading source connected
to the side-fill. The side-fill is stationary on the right side of the machine. The rinse connection is located di-
rectly above the solution fill connection.
To fill the solution tank, follow these steps:
1. Connect the loading supply to the side-fill connection.
2. Open the solution fill valve on the side-fill (fig. 4.54-2, item 1)
3. Open the sump valve under the tank (fig. 4.54-1, item 1)
4. Fill to the desired level not to exceed 2000 gallons.
5. Close both valves before disconnecting supply.
6. Replace cap to protect opening.
To rinse the tank and spray system, follow
these steps:
1. Connect the source of fresh water.
2. Open the rinse connection valve (fig. 4.54-2,
item 2).
3. Rinse the entire spray system, including the
booms, by allowing the tank to fill to adequate
rinse level and run the spray system as you would
while spraying chemicals.
OPERATING SYSTEMS
FIG 4.54-2
1
2
NOTE:
Follow all regulations regarding the disposal of
waste chemicals and cleaning agents. Do not
allow them to contaminate a water supply!
FIG 4.54-1
2
1
