With the Edge Light Plow attached:
Once the tank temperature reaches 50°F, increase the engine RPM to high idle. Move the machine into a safe
area and stop.
1. Turn the work mode switch to ON and float switch to OFF.
2. Turn the speed control knob backwards completely.
3. Press the Green button on the hydrostat handle to activate the brushes.
4. Slowly turn the speed control knob forward until the brushes start to turn.
5. Raise and lower the plow three times.
6. Raise the plow completely and raise and lower the plow tip three times.
7. Open and close the plow doors completely three times.
8. Slowly increase the speed of the brushes.
9. Start the machine moving forward slowly (3 MPH Max) and turn left and right (lock to lock) 3 times.
10. Check the hydraulic tank temperature, if it is above 80° the machine is ready to be used.
39
OPERATING SYSTEMS
IV.
OPERATING SYSTEMS
B. HYDROSTATIC DRIVE SYSTEM
