40
IV.
OPERATING INFORMATION
DEPTH COMMAND
The Hagie 2101 SPRAYER/DETASSELER
comes with adjustable DEPTH COMMAND (fig.
4.31). This allows the operator to adjust the depth
of the LS system from the cab. The switches are
located to the right of the operator’s seat above the
console (fig. 4.32).
To lower the cutting or pulling height, select the
appropriate switch and push down. This will extend
the actuator (fig. 4.31, item 1), raising the LS sys-
tem, which in turn lowers the cutting or pulling
height. To raise the cutting height, lower the actua-
tor by pushing the appropriate switch up.
NOTE:
DO NOT operate more than two actuators
at one single time. This may blow the
fuse located on the switch panel (fig.
4.32). For more information on the
DEPTH COMMAND fuse, see page 44.
FIG 4.31
FIG 4.32
1