TX100 USB
6
6T7639a
1.5.2 Continuing or modifying the configuration of a saved project
The tools are the same than for the creation of a new project, but, in addition, the file containing the project data must be
available.
The project file is either:
-
in the TX100, this is the last project created with this tool.
-
or in an external memory (USB stick, PS, SM card) if it is a previous project or a project configured with another TX100. This
project file will then be loaded in the internal memory of the TX100.
Note: In this case, the project file that is possibly present in the TX100 will be lost and replaced by the loaded file.
!
If the project file is lost, the TX100 has advanced functions allowing to learn again an installation.
2.1.1 Inserting rechargeable batteries or dry-cell batteries
2.1.2 Battery life and load
2. Commissioning, start-up and basic settings of the TX100
2.1 Commissioning the TX100
• Remove screw A.
• Open cover B to access the battery compartment..
• Position switch C according to the power supply being used:
- Position 1: Powered by dry-cell batteries.
- Position 2
(by default at delivery)
: Powered by rechargeable batteries
(supplied).
• Insert dry-cell batteries or rechargeable batteries ensuring that the polarities are
respected, then close and screw down the cover.
If you are using rechargeable batteries, connect the mains charger provided to socket D.
The battery level indicator is displayed during loading:
If the charger is connected to the device when it is operating on dry-cell
batteries and the selection switch is still in the rechargeable battery position,
there is a risk of destroying the Tebis TX100 configurator.
Charge the battery completely before the first use (3 h 30 min
approximately).
A
B
C
1
2
D
