TX100 USB
31
6T7639a
After the Product learning, Inputs/outputs numbering and Inputs function assignment phases, the Input/output links creation
phase can begin.
The TX100 offers several possibilities to create links:
➜
Creating a simple link: a link is created between an input and an output.
➜
Creating a multiple link: a link is created between an input and several outputs in one single operation.
➜
Creation of a link by means of Copy/Paste of an input into another input.
➜
Creation of a link using the +Info filter.
The creation of a link may require setting an additional parameter (for example a lighting delay).
5.6.1 Creating a simple link
The creation of links is performed in the Programming mode.
The Prog screen is similar to the screen below.
Example:
A pushbutton ON function was assigned to the unidirectional RF input number 8.
5.6 Creation of links and input of additional parameters
Select an input.
• Press the left
keys to select the input to be linked.
or
• Activate the input to be linked.
• The number and the function of this input are then displayed.
Select an output.
• Press the right
keys to select the output to be linked.
!
When the output is equipped with manual command pushbuttons (modular
products), press the pushbutton, the corresponding output is selected.
• To find and locate physically an output, press briefly
: The selected output is
activated (the action depends on the product).
!
The central screen key facilitates function selection by allowing you to activate a
function filter to limit scrolling to a family of functions.
The All filter corresponds to all functions.
Selecting the Lighting, Shutters, Heating filter allows displaying only the functions of the
selected type.