TX100 USB
39
6T7639a
7.2.5 Removing a product from the project
Removing a product consists in resetting it to its factory status and removing it from the products list displayed in the Menu /
Product management / Product information screen. A removed product can be removed physically from the installation and re-
used in another installation.
To remove a product, go to the screen Menu / Device management / Delete:
If inputs or outputs of the product were linked with other inputs or outputs, this modification will lead to faults and must be
followed by a download. (Go to Menu / Device management / Download): the faulty product is indicated by !, select the product
and confirm with
to start the download).
Programming in expert mode requires basic KNX knowledge (for example, ETS software).
Expert mode includes the following functions:
- Extension of the communication system:
Grants access to the group address given during programming in Standard mode in order to set up links between a
Tebis TX installation (TP, radio KNX) and Hager devices such as technical alarms, displays, Internet gateways.
- Programming of mixed installations (KNX and Tebis).
Expert mode allows integrating KNX RF products in an installation parameterised with ETS.
- Programming of additional functions:
To maintain ease of programming in Standard mode, certain of the device's functions may not be available in that
mode. Therefore, certain specific solutions are reserved for Expert mode.
• Select the product to be removed using the key
or
.
• Press the
key to confirm your selection.
• Press the YES screen key to confirm the removal of the product.
!
At the next numbering, the numbers of the inputs or outputs of the removed product
will be re-assigned first.
8. On-line configuration of a new installation in Expert mode
8.1 General points