BloodTrack Kiosk® V5 Installation Guide
HAE: SM-BloodTrack-08(AA)
SBC100xxx
GBE: 2000-JNB0012
2
The BloodTrack Courier software running on the Kiosk V5 controls access to the
storage location via electromagnetic locks. The BloodTrack Kiosk V5 can drive a
lock on one or more storage locations via independent relay outputs. These locks
may be an electromagnet powered from the BloodTrack Kiosk V5, or an auxiliary
input provided by the storage location.
The BloodTrack Kiosk V5 can be wall-mounted (or other suitable vertical surface),
or located on a desk stand on a suitable flat surface, next to the storage location. It
may also be integrated into a storage location cabinet.
WARNING
!
If the BloodTrack Kiosk is mounted on a free-standing piece of equipment (for
example, desktop or table top), it must
not
be mounted on an uneven or non-
stationary surface. The BloodTrack Kiosk must
not
be mounted on any surface
that has potential to move or shake. For example,
NEVER
mount the
BloodTrack Kiosk on top of a refrigerator as the movement caused by the device
door would quite likely cause the BloodTrack Kiosk to shift or to tip over. Failure
to take this precaution may result in personal injury and equipment damage
The BloodTrack Kiosk V5 is installed (after a site survey) by trained professionals.
The BloodTrack Kiosk V5 is used by authorized personnel and installation/servicing
technicians. All users will be fully trained in the proper operation of the hardware by
a system administrator who has been trained by Haemonetics (the reseller of the
BloodTrack Kiosk V5). All users are recommended to have a certificate of
competence in the use of the Haemonetics BloodTrack Courier software.
Access is only available to users fully trained, with the appropriate access rights. All
authorized users of the BloodTrack software have a unique identification barcode
—
usually attached to their employee identification card. The user logs on to the
software by scanning an identification badge barcode, using the barcode scanner on
the BloodTrack Kiosk V5. When the barcode is scanned, the BloodTrack Courier
software tests it for validity. If the barcode is a valid User ID barcode, the
BloodTrack Courier software compares the barcode with the User ID codes in the
valid user list.
The BloodTrack software is a modular blood management and bedside transfusion
solution that combines software with hardware components to act as an extension
of the blood bank transfusion management system.
Through integrated modules, the BloodTrack software provides the control, visibility,
and traceability needed to safely and properly store, dispense, and transfuse blood
products at the point-of-care and verify that the
right
blood is transfused to
the
right
patient at the bedside, while helping achieve compliance.