83
Replacing an SFP+/QSFP+/QSFP+ to SFP+ copper cable
CAUTION:
•
The bend radius of the cable must be a minimum of eight times the cable diameter.
•
Do not use excessive force to remove the cable. If the cable cannot be removed or installed, verify that
the removal or installation procedure is correct.
•
When you remove the cable connector from the port, pull the pull latch horizontally for smooth
removal and avoiding damage.
To replace an SFP+/QSFP+/QSFP+ to SFP+ copper cable:
1.
Wear an ESD wrist strap, and make sure it makes good skin contact and is reliably grounded. For
more information, see "
."
2.
Gently press the cable connector in, and then pull the pull latch on the cable outward to pull out the
cable connector.
3.
Connect a new SFP+/QSFP+/QSFP+ to SFP+ copper cable to the port.
For the connection procedure, see "
."
4.
If you are not to connect a new SFP+/QSFP+/QSFP28/QSFP+ to SFP+ copper cable to the port,
insert the dust plug that is provided with the LPU into the port.
Summary of Contents for S12500-X
Page 35: ...26 Figure 20 Grounding the switch through the RTN wire of the DC power module...
Page 80: ...71 Figure 51 Replacing an LPU 1 1 Loosen the captive screw 2 Pull the ejector levers outward...
Page 138: ...129 Figure 75 CXP fiber cable 1 Connector 2 Pull latch 1 2...
Page 152: ...143 Figure 91 Cable routing from the left side for an S12510 X AC S12510 X DC switch...
