153
2.
Put the wooden pallet base to a proper place.
3.
As shown in callout 1 in
, use a Phillips screwdriver to loosen the screws that attach the
mounting brackets to the rack.
4.
As shown in callout 2 in
, cooperate with a minimum of three people to slide the chassis
outwards along the slide rails. When most part of the chassis is removed from the slide rails, lift up
the chassis by holding the handles at the chassis sides to completely remove the chassis from the
rack.
5.
Put the chassis onto the wooden pallet base.
Figure 100
Removing an S12510-X AC from the rack
(1) Loosen the captive screws that attach the mounting brackets to the rack
(2) Slide the chassis outwards along the slide rails
Removing the power cord bracket (S12510-X AC and
S12516-X AC switches)
Remove the power cord bracket before you repack an S12510-X AC switch or an S12516-X AC switch.
The power cord bracket is attached to the power distribution box on the rear panel of the switch.
To remove the power cord bracket:
1.
Prepare the packing bag and box of the power cord bracket. Make sure they are clean, dry, and
not damaged.
2.
Use a screwdriver to loosen the screws that attach the power cord bracket to the chassis and
remove the power cord bracket from the chassis.
3.
Put the power cord bracket into the bag.
4.
Put the packed power cord bracket into the box.
2
1
1
Summary of Contents for S12500-X
Page 35: ...26 Figure 20 Grounding the switch through the RTN wire of the DC power module...
Page 80: ...71 Figure 51 Replacing an LPU 1 1 Loosen the captive screw 2 Pull the ejector levers outward...
Page 138: ...129 Figure 75 CXP fiber cable 1 Connector 2 Pull latch 1 2...
Page 152: ...143 Figure 91 Cable routing from the left side for an S12510 X AC S12510 X DC switch...
