7
Figure 8 Removing a subcard
Replacing a hard disk
CAUTION:
Do not hot swap a hard disk when the operating system on the hard disk is running.
To replace a hard disk:
1.
Prepare an antistatic mat to place the removed hard disk.
2.
Put on an ESD wrist strap, and make sure the wrist strap makes good skin contact and is
reliably grounded. For more information, see "Attaching an ESD wrist strap."
3.
Press the button on the hard disk panel. The hard disk panel will open automatically.
4.
Gently pull out the hard disk along the guide rails.
5.
Install the new hard disk. For more information about how to install a hard disk, see "Installing a
hard disk."
Figure 9 Removing a hard disk
1
2
2
3
1
2
Summary of Contents for CR16000-F
