WS-4R / WS-4L
EN
DEVICE PRESENTATION (I)
1-
Reel support (200 or 300mm)
2-
Wire feeder
3-
Handle
4-
Wire speed potentiometer
5-
Euro torch connector
6-
Upper section of the swivel support
7-
Gas connector of the connecting harness
8-
Control cable connector
9-
Power cable connector
10-
Eye rings (Don’t lift by the handles (3))
11-
Setting connection base
12-
Hose clamp
ASSEMBLY & CONNECTION (I & II)
Installing the swivel support on the generator
Use the 3 screws (included with the generator) supplied to fix the bottom part of the swivel support onto the generator
The upper part of the support is already fixed under the wire feeder.
Connection of interconnection cable:
1
2
3
Wire feeder supplied uncovered
Fix the base at the back of the wire
feeder.
Insert the command cable
4
5
6
Insert the power cable
Insert the remaining pipes
Connect the interconnection cable*
7
*water connection: Only for 500 WS
Generator
Fix power cable with holding device (Fig
2 - 13).
Adapt the sheath on the base and tighten
hose clip
WIRE REEL INSTALLATION (III)
• Open the door of the machine.
• Position the reel on to the support (1) taking care of the pin.
• Adjust the break (2), to avoid reel movement tangling the wire when the welding stops.
• Tighten the plastic screw firmly (3).
• For the first use :
- Release the fixing screw of the wire guide (4)
- Put the rollers in place (5). The visible diameter on the roller should be equal to the wire diameter used.
- Place the wire guide (6) as close as possible to the roller but without touching it, then tighten the fixing screw.
• To select the adjustment of the drive rollers: loosen the drive roller knob as far as possible (7), insert the wire until it exits the other side by about
2cm. Start the motor by pressing the torch trigger, tighten the knob whilst pressing the trigger. Bend the wire where it comes out of the nozzle and
hold it in place to stop its progress - the setting is correct when the guide roller slides over the wire, even when it is blocked at the end of the torch.
11
