GW Instek LCR-8101, User Manual, Page: 47 / 59

GRAPH MODE
93
Observe Graph Data
Background
When the graph is completed (page90) and the
vertical scale is adjusted (page92), use the marker
to observe the measurement data in detail.
In the configuration mode, if the graph
is already available, it can be viewed by
pressing F6 (View).
F 6
Panel operation
1. To move the marker, press the
Left/Right key. As the marker
moves, the marker position and
measurement data changes.
CAPACITANCE VS FREQUENCY
FUNCTION
RETURN
20.0 40.0 60.0 80.0 100
(Hz)
300.0n
250.0n
(F)
MKR: 32.000 Hz
Cs : 250.00nF LEVEL: 10.0mV
SPEED:FAST
Marker
Marker position and
Measurement data
Move marker to
the peak
2. To move the marker to the peak of
the plot, press F1 (Function) and F3
(Peak). Press F1 (View) to go back to
the previous display.
F 1
F 3
Move marker to
the bottom 3. To move the marker to the bottom of
the plot, press F1 (Function) and F4
(Dip). Press F1 (View) to go back to
the previous display.
F 1
F 4
LCR-8101 User Manual
94
R
EMOTE CONTROL
This chapter describes basic aspects of IEEE488.2
based remote control. Both RS-232C and GPIB
interface can be used for remote control. For more
details such as full length command, refer to the
programming manual downloadable from
GWInstek website,
www.gwinstek.com.tw .
Configuration Configure RS-232C interface ........................... 95
Configure GPIB interface ................................ 96
Command syntax Command Syntax ............................................ 98
Command set System command ........................................... 99
Measurement command ................................100
Multi-step program command .......................102
Calibration command ....................................104