GVM-VAC GVM6600-CM, Owner'S Manual

Page: 40 / 131

40
GVM-VAC
www.gvm-vac.com
Maintenance Section
4.2 Maintenance and Lubrication
This chart is only a reference, always consult the Owners Manual of the Engine, PTO, etc for actual recommendations
Check and add engine oil, coolant, fuel and
Hydraulic fluid (hoist and boom)*
Check for loose nuts or bolts
Check for fuel, oil, coolant and hydraulic leakage*
Check or clean radiator screen
Lubricate impeller shaft flange bearings(if equipped)
Check lug nuts and tire pressure / condition
Check trailer safety chains and hitch
Check tow bar for damage or wear
Check and clean instrument panel and circ. board
Clean pre-cleaner
Check air filter for dirt or debris*
Check trailer lighting and trailer brake operation
Change engine oil*
Clean and check battery and connections*
Check power band tension (if equipped)
Check power band condition (if equipped)
Check impeller for damage, cracks or wear
Grease (non-conductive) circuit board connectors
Clean hydraulic pump motor/connections
Lubricate throttle and choke cables
Check blower housing liners for cracks or wear
Check Clutch/PTO linkage adjustment
Change hoist hydraulic fluid and filter
Change boom hydraulic fluid
Inspect intake and exhaust hoses for damage
Check exhaust duct gasket for wear
Replace oil filter*
Replace air filter primary element*
Inspect radiator and hoses*
Check fan belt conditions and tension*
Inspect all duct work for cracks, holes or wear
Grease / Inspect wheel bearings for corrosion
Change engine coolant*
Check fuel tank for leaks
Lubricate Hoist and Hinge Fittings
MAINTENANCE
INTERVAL
Daily First
8
Hours
Every
25
Hours
Every
50
Hours
Every
100
Hours
Every
200
Hours
* = see the engine owner's manual for complete details
(Use Hour Meter as a Guide)