8108506
Wireless Keyboard
8011241
USB 2A-B cable (2 meters)
8108380
USB 10 meter Cable
Optional Accessories
8100465
Isolation Transformer
8105676
DD45 Contra Headset P3045*
* = Applied part (the part of the medical device which comes into physical
contact with the patient).
Initial Set Up
Place the instrument on a stable counter or table where it will be used. The
location should be near a properly grounded wall outlet. Carefully attach
purchased accessories to their appropriately labeled connectors on the instrument.
Locate the power
switch on the right side panel of the instrument and move the
switch to the On
position
.
When power is turned on, the light on the LCD will be
illuminated and the display on the LCD will display information to
indicate the
system is initializing. After the system has completed initialization, the lights
on
the probe box will be lit.
The system will power up to the factory default test mode (to set user-defined
power up setting, see the information regarding the PC configuration software)
and the probe green lamp will begin to blink indicating that the instrument is
ready to begin the testing. If both the green and yellow lamps are illuminated at
the same time following power on, the probe is occluded or the tympanogram
software did not initialize properly. Simply move the power switch to the off
position, inspect the probe tip for any signs of an occlusion, and reposition the
power switch to On.
If both green and yellow lamps are still illuminated and the
probe is not occluded, contact a local service representative or the GSI service
department for repair.
Allow the instrument to warm-up for about 10 minutes before conducting a test.
This allows the electronic circuits to stabilize prior to use. If the storage
temperature is lower than the room temperature, allow additional time for the
instrument to reach room temperature.
NOTE:
Part numbers may change periodically. Please check with your Grason-
Stadler representative for current part numbers.
Summary of Contents for TYMPSTAR PRO
Page 2: ...D 0105594 Rev G i...
Page 7: ......
Page 27: ...GSI Part number Return to authorized representative special disposal required Manufacturer...
Page 98: ......
