Warning - General
Proper use of this device depends on careful reading of all instructions and labels.
Follow all safety standards set by each place of employment.
No modifications of the equipment are allowed by anyone other than a qualified
GSI representative.
Warning - Connecting Additional Equipment
Accessory equipment connected to the analog and digital interfaces must be
certified to the respective IEC standards (IEC 950 for data processing or IEC
60601-1 for medical equipment and/or appropriate European Directives).
Furthermore, all configurations shall comply with the system standard IEC
60601-1-1. Everyone who connects additional equipment to the signal input or
signal output port configures a medical system per the standard IEC 60601-1-1.
If in doubt, consult the technical service department or a local GSI representative.
Connect all nonmedical equipment to the GSI Isolated Power Supply.
The AC power outlets on the isolated transformer/power box are intended for use
with GSI approved components only. Use of any other equipment may result in
damage to the power unit. Follow all safety standards set by each place of
employment.
NOTE:
If the instrument is connected to a PC, power to the monitor and
computer must be controlled by the isolation transformer. Always leave the
monitor and computer power switches in the ON position and control power from
the isolation transformer. Always turn OFF system power before connecting or
disconnecting system components to help guard against personal injury.
Warning - Electric Shock Hazards
Do not open the case of the GSI Instrument. Do not remove any GSI instrument
covers. Refer servicing to qualified personnel.
Warning - Electric Grounding
To avoid the risk of electric shock, this equipment must only be connected to
supply mains with protective earth.
This device uses a three wire power cord with a hospital grade plug (for
international applications, IEC 60601-1 approved plug). The chassis is earth
grounded. For grounding reliability, connect the device to a hospital grade or
hospital only receptacle (for non US applications, IEC 60601-1 approved
receptacle). Inspect the power cord often for fraying or other damage. Do not
operate the apparatus with a damaged power cord or plug. Improper grounding is
a safety hazard. Periodically check the system ground integrity.
Summary of Contents for TYMPSTAR PRO
Page 2: ...D 0105594 Rev G i...
Page 7: ......
Page 27: ...GSI Part number Return to authorized representative special disposal required Manufacturer...
Page 98: ......
