2. From the inside of the bin, insert the angle ring end of the unload tube through the hole in the bin
sidewall.
NOTE:
Before installing tube, remove flight from the inside of the tube.
3. Insert the unload tube (2 and 3) into the center well (1) till the tube flange aligns to the outside of the
center well and secure using serrated flange bolts (4) serrated flange nuts (5).
NOTE:
• For 8" – Four (4) 3/8 x 3/4 in. bolts
• For 10" – Six (6) 3/8 x 3/4 in. bolts
Figure 3-4
Secure the center well to unload tube
1
Center well
4
3/8 x 3/4 in. serrated flange bolt
2
Unload tube
5
3/8 in. serrated flange nut
3
Unload tube flange
NOTE:
In order to install the carriage bolts, the gate needs to be attached to the pipe PRIOR to
assembling the tube to the center well. Extend the center well pipe off the end of the tube
and slide the gate out of the well. This will give the space to tighten the nuts.
20
PNEG-2108
8" and 10" Standard Duty and IW Standard Duty
