1. Safety
PNEG-1162CEX
DMC DIII Stir-Ator
5
Installation
1. The correct installation procedure is outlined in this manual.
2. Always install all recommended safety devices, such as safety isolators, grain level switches and
door isolators. Failure to do so is a misuse of the equipment and may result in unsafe operation.
3. Always use the recommended flexible cable (type HO7). Failure to do so may result in damage to
the electrical cable and risk electrical shock.
4. All electrical wiring should be in accordance to EN60204:1998.
5. All electrical installation must be carried out by a suitably qualified electrical engineer.
6. The system and all associated steel work must be safely earthed.
Operation
1. Read and understand the owner’s manual.
2. Keep all safety shields in place.
3. Prior to inspecting, servicing, lubricating or adjusting the Stir-Ator, ensure the isolator switch is locked
in the “OFF” position, with the only key in the possession.
4. Do not operate the Stir-Ator unless shut off chain has been properly installed and adjusted.
5. NEVER enter the bin while the Stir-Ator is in operation.
6. In the event that an auger becomes bound, the system should be switched OFF, isolated and locked
OFF before any attempt to release the auger.
7. Operating the Stir-Ator during bin unloading can be beneficial to the unloading process as well as
prevent auger damage.
8. DO NOT OVER FILL THE GRAIN BIN. BURYING THE STIRRER WILL DAMAGE BIN AND WILL
VOID THE DESIGN III WARRANTY.
9. DO NOT OPERATE DESIGN III STIR-ATOR IN AN EMPTY BIN.
