GSi DMC DIII Stir-Ator, Owner'S Manual

Page: 27 / 36

5. Installation
PNEG-1162CEX DMC DIII Stir-Ator 27
Centre Suspension Assembly
The triple auger units use a “T” shaped suspension bar, whilst double auger units use a straight bar.
7. Assemble the “T” piece. (See Figure 5AQ.) (Straight suspension bar requires no assembly.)
Figure 5AQ Assemble “T” Suspension Bar
8. Slide the attachment link over the suspension bar and fix it to the upper shaft bracket on the slip ring,
using a grade 8, 1/2" x 2" bolt, lock nut and washer. (See Figure 5AR.)
Figure 5AR Attach Suspension Bar
Lifting Stirrer into Position
The stirrer is now ready to hoist into position.
9. Use a suitable lifting block and tackle or other device, lifting from the centre of the suspension bar
and track motor end simultaneously.
10. Before lifting, move the auger trolley towards the centre of the bin and clamp it in place to stop it
rolling backwards and forwards.
11. When the suspension bar is about 450 mm above the eave height, the ends of the suspension chains
should be placed through loops and around the tube ends and hooked back on the main strand with
the “S” hooks.
(See Figure 5AS on Page 28.)
Double auger
suspension bar
Attachment link