5. Installation
PNEG-1162CEX
DMC DIII Stir-Ator
13
4.
NOTE:
Augers used in 11 m or wider grain bins require the trolley hold-down rods to be moved to
the bottom hole position. This is done by removing the cotter pin and pulling the rod out and
reinserting it in the bottom holes.
.
Figure 5J Auger Trolley
Figure 5K Trolley Hold-Down Rod
5. Place the auger trolley onto the frame, as shown
. Check the orientation
of the trolley in relation to the track drive unit and bin wall.
6. Fit the auger trolley drive post and arm, using the lower hole in the post and two (2) cotter pins
(one below, one above the trolley) provided.
Hold-down
rod holes
Hold-down rod
