5. Installation
PNEG-1162CEX
DMC DIII Stir-Ator
17
12.
NOTE: 36' and larger units have an additional center support yoke. Attach the top end of the support
yoke to the center extension tube using a 1-3/4" spacer tube, one 3/8" x 2-1/2" hex head bolt and hex
lock nut. Locate approximately 4" from wire support swing arm toward outboard end side. Place
bottom of support yoke onto the frame rail angle flange and fasten with 3/8" x 1" set screw.
(See Figure 5U and Figure 5V.)
Figure 5U Fit Intermediate Yoke and Cable Swing Arm
Figure 5V Attach Yoke to Steel Angle
13. Attach the slip ring unit to the centre yoke assembly using a 1/2" x 3" bolt, lock nut and roll pin as
shown
.
Figure 5W Slip Ring Unit
