GSi DMC DIII Stir-Ator, Owner'S Manual

Page: 12 / 36

5. Installation
12 PNEG-1162CEX DMC DIII Stir-Ator
Stirrer Assembly
1. Separate the two (2) rails and place them on two (2) saw horses and remove the two (2) bolts holding
the frame rails together, spacing them approximately 200 mm apart. (See Figure 5G.)
Figure 5G Place Stirrer Rails
2. Fit the outboard frame end using six (6) carriage bolts, nuts and lock washers. Ensure the bolt
heads are inside the rails. Ensure the marking 1-1/2" is uppermost when fitting the frame end.
(See Figure 5H.)
Figure 5H Fit Outboard Frame Ends
3. Attach the track drive unit. (See Figure 5I.)
Figure 5I Track Drive Unit
Track drive unit
Carriage
bolts