5. Working down from the starter brackets (C and K), and in alignment, install a ladder standoff bracket
(H) at every horizontal seam or 32 in. from the previous installed bracket. Install a flange bolt (D)
and a flange nut (G), securing each ladder standoff bracket (H) to the sidewall.
NOTE:
Installing a plumb line to the starter bracket will help keep each bracket aligned evenly.
6. Install a ladder reinforcing strap (I) to the ladder standoff brackets (H), and install two hex bolts (J)
and nuts (G).
NOTE:
For optimal reinforcement, install the ladder reinforcing straps (I) in a diagonal fashion as
shown.
7. Tighten hardware to the recommended torque specifications. See
Bolt Torque Specifications, page
8. Install the ladder (B) to the starter brackets (C and K), and install hex bolts (M) and nuts (N), but do
not tighten at this time.
9. Install a carriage bolt (Q) to a standoff wedge (O), and insert into the outside channel of the ladder
assembly (B).
10.Connect the standoff wedge (O) to the standoff bracket (H), and install a flange nut (P), but do not
tighten allowing, for adjustment.
PNEG-4472
72 Ft Diameter Z-Tek Bins
155
Summary of Contents for 40-SERIES
