Automatic water analysis system
GENO-softwatch Komfort
Order no. 145 172 955-inter Edited by: phar-mrie G:\BA-172955-INTER_145_GENO-SOFTWATCH KOMFORT
13
3 | Technical specifications
Table C-1: Technical
specifications
Automatic water analysis system
GENO-softwatch Komfort
Connection data
Nominal connection diameter
inlet/outlet
[mm] 6/8
Operating pressure
[bar]
0.5-5 (1-2 recommended)
Required drain connection
[DN]
50
Power supply
[V]/[Hz]
85 – 264 V AC / 47 – 63 Hz
all-phase power switched off
Max. power input
[VA]
25
Protection/protection class
IP 54/
Dimensions and weights
Dimensions approx. (w x h x d)
[mm]
350 x 250 x 140
Approx. weight
[kg]
2
Consumption data
Indicator consumption
[ml]
< 0.10/analysis
Range indicator bottle 500 ml
> 4000 analyses
Water consumption, approx.
[ml]
1000
Ambient data
Humidity
20 – 90 % (RH non-condensing)
Ambient temperature
[°C]
5 – 45
Water temperature, min./max.
[°C]
5/40
Order no.
172 500
4 | Functional Description
The GENO-softwatch Komfort is installed in a branch line of the soft
water pipe.
The main components of the automatic water analysis system are
the photometric measuring chamber with receptacle and non-wearing
stirring device, the dosing unit for the indicator and the control
electronics.
Following the flushing of the feed line and the measuring chamber,
the fully automatic titration takes place. The indicator is added by
means of a dosing pump. After a settling period, the photometric
evaluation of the water sample is carried out. Depending on the
colour change, the water sample is either above or below the limit
value (green = good measurement; red = bad measurement) and
depending on the colour, a visual alarm signal will be released.
A voltage-free output to connect an acoustic alarm on site is provided.
