Grizzly Polar Bear G0833P, Owner'S Manual, Page: 67 / 92

Model G0833P (Mfd. Since 06/17)
-65-
3. With end of adjustable square just touching
tip, lock square in place. Now, mark car-
bide tip with a marker where you made this
measurement.
Miter Slot to Blade
Parallelism
Your table saw will give the best results if the
miter slot and the rip fence are adjusted paral-
lel to the blade. If either of these are not exactly
parallel, your cuts and your finished work will be
lower in quality, but more importantly, the risk of
kickback will be increased.
Tools Needed Qty
Adjustable Square ............................................. 1
Marker ............................................................... 1
Metal Shim Stock .............................. As Needed
Hex Wrench 6mm .............................................. 1
To adjust blade parallel to miter slot:
1. DISCONNECT SAW FROM POWER!
2. Tilt blade to 0°, then use an adjustable square
to measure distance from miter slot to a car-
bide tip on blade, as shown in
Figure 110.
Make sure that face of adjustable square is
even along miter slot.
The saw blade is sharp. Use extra care or
wear gloves when handling the blade or
working near it.
4. Rotate marked blade tip to other end of table
insert.
5. Slide adjustable square down to other end
of table insert and compare distance from
marked blade tip to end of adjustable square,
as shown in
Figure 111.
— If blade tip measurement is same on both
sides, go to Step 8.
— If blade tip does not touch end of adjust-
able square similar to first measurement,
table will need to be adjusted. Proceed to
Step 6.
Blade tilted to 0º
Front
B
STEP B
Figure 111. Measuring distance from miter slot
to carbide tip on opposite side of table insert.
Figure 110. Example of adjusting blade to miter
slot.
Blade tilted to 0º
Front
STEP A