Grizzly Polar Bear G0833P, Owner'S Manual, Page: 29 / 92

Model G0833P (Mfd. Since 06/17)
-27-
4. Fit 4" dust hose over dust port, as shown in
Figure 33, and tightly secure it in place with
a hose clamp.
Components Needed: Qty
Dust Hose Adapters 1
1
⁄
2
" ....................................2
Dust Hose 94" x 1
1
⁄
2
" ..........................................1
Dust Hose 4 " (not included) ...............................1
Hose Clamps 4" (not included) ..........................2
Dust Collection System (not included) ...............1
Dust Collection
Minimum CFM at Dust Port: 500 CFM +
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
This machine creates a lot of wood chips/
dust during operation. Breathing airborne
dust on a regular basis can result in perma-
nent respiratory illness. Reduce your risk
by wearing a respirator and capturing the
dust with a dust collection system.
2. Slide one adapter onto 1
1
⁄
2
" dust port (see
Figure 32), until it fits snugly.
3. Attach dust hose to dust hose support, then
insert dust port into rear of blade guard
assembly (see
Figure 32).
To connect dust collection hoses:
1. Attach a dust hose adapter to each end of
dust hose (see
Figure 31).
Figure 31. Adapters attached to dust hose.
Adapters
Figure 32. Dust hose attached to saw, hose
support, and blade guard dust port.
Hose Support
Figure 33. Dust hoses attached to port.
4" Dust Hose
Hose Clamp
1
1
⁄
2
" Dust
Port
5. Tug hose to make sure it does not come off.
Note: A tight fit is necessary for proper perfor-
mance.
Blade
Guard
Dust Port
4" Dust
Port