Grizzly Polar Bear G0833P, Owner'S Manual, Page: 30 / 92

-28-
Model G0833P (Mfd. Since 06/17)
To test run machine:
1. Lower blade all the way down, and make sure
all tools and objects used during setup are
cleared away from machine.
2. Connect machine to power source.
3. Turn machine ON, verify motor operation,
then turn machine
OFF.
The motor should run smoothly and without
unusual problems or noises.
5. Press green ON/START button to test dis-
abling feature on switch.
— If machine does not start, switch disabling
feature is working as designed.
— If machine does start, immediately stop
machine. The switch disabling feature is
not working correctly. This safety feature
must work properly before proceeding with
regular operations. Call Tech Support for
help.
ON / START
Button
Pin
OFF / STOP
Paddle
Figure 34. Example of switch disabling pin
inserted into START button.
4. Insert switch disabling pin through green ON/
START button, as shown in Figure 34.
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
The test run consists of verifying the following:
1) The motor powers up and runs correctly, and
2) the safety disabling mechanism on the switch
works correctly.