Grizzly Polar Bear G0833P, Owner'S Manual, Page: 25 / 92

Model G0833P (Mfd. Since 06/17)
-23-
7. While a helper holds wings in place, attach
each extension wing to main table with (3)
M10-1.5 x 25 cap screws, 10mm lock wash-
ers, and 10mm flat washers removed in
Step 5 (see Figure 20).
— If outside end of extension wing tilts up,
place strip of masking tape along top edge
of main table to shim end of extension wing
down (see
Figure 22).
Note: After re-installing wings, remove all
excess masking tape with a razor blade.
Figure 22. Masking tape location for adjusting
the extension wing down.
8. Place straightedge across extension wings
and main table to make sure that combined
table surface is flat.
— If combined table surface is flat, skip to
next step.
— If outside end of extension wing tilts down,
place a strip of masking tape along bottom
edge of main table to shim end of exten-
sion wing up (see
Figure 21).
Figure 21. Masking tape location for tilting
extension wing up.
Figure 20. Extension wings installed.
x 3
9. Attach front rail to table and extension wings
with (4) M8-1.25 x 35 flat head screws,
8mm flat washers, 8mm lock washers, and
M8-1.25 hex nuts, as shown in
Figure 23.
Make sure top of rail is parallel with table top
before fully tightening fasteners.
Figure 23. Front rail installed.
Equal
Front Rail
x 4
Main Table
Extension
Wing
(1 of 2)