Grizzly Polar Bear G0833P, Owner'S Manual, Page: 24 / 92

-22-
Model G0833P (Mfd. Since 06/17)
4. Slide groove on back of each handwheel over
handwheel shaft pin, as shown in Figure 18.
3. Before closing door, thoroughly clean heavy-
duty rust preventative off of gearing inside the
saw and coat these with appropriate metal
protectant (refer to
Lubrication on Page 60
for location of gears).
To assemble table saw:
Figure 17. Motor door installed.
Hinge
Socket
2. Remove switch from saw cabinet, and install
motor door by inserting door pins into hinge
sockets on cabinet (see
Figure 17).
Assembly
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to
Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
1. Using blade height handwheel (refer to
Page 3), raise motor and remove foam ship-
ping block (see
Figure 16). Save block for
later machine transport.
Figure 16. Foam shipping block location.
5. Thread a handwheel lock knob into center
of each handwheel and tighten, then thread
a handle onto each handwheel and tighten
(see
Figure 19).
Figure 19. Handwheel installed.
Handles
6. Inspect extension wings and main table mat-
ing surfaces for burrs or foreign materials that
may inhibit assembly.
For a correct fit, mating edges of table and
wings must be clean, smooth, and flat. If nec-
essary, use a wire brush or file to remove any
flashing, dings, or high spots.
Figure 18. Handwheel installed onto shaft pin.
Pin
Groove
Handwheel